The Matek 8 Bit WS2812B RGB 5050 Highlight LED for Naze32 CC3D has built-in controller chip so only one IO port is needed to control multiple LEDs. On-chip shaping circuits prevent signal distortion to accumulate for stable display. The module supports trichromatic 256 brightness adjustment, with scan frequency not less than 400Hz/s. Serial connection-level interface makes it possible to finish receiving and decoding data through a signal line. Both ends have interfaces (DIN DOUT) that can be cascaded. The LED lights can show the flight control lock / unlock status, left and right aileron, brake, throttle, alarm and other status.

FEATURES

• Built-in controller chip, only need an IO port to control multiple LEDs
• On-chip shaping circuits prevent signal distortion to accumulate for stable display
• Trichromatic 256 brightness adjustment, with scan frequency not less than 400Hz/s
• Serial connection-level interface, finish receiving and decoding data through a signal line
• Both ends have interfaces (DIN DOUT) that can be cascaded
• The LED lights can show the flight control lock / unlock status, left and right aileron, brake, throttle, alarm and other status Note: If it is used for Naze32 or CC3D flight control, it needs to brush CleanFlight, and using PPM receivers. When used for CC3D flight controller, you should pay attention to the following points:
• CC3D needs to brush CleanFlight firmware.
• Use PPM / SBUS receiver instead of PWM receiver.
• GND 5V DIN behind the lights should be connected to CC3D fifth row - + S of the motor output side.
• Choose PPM receiver in the CF´s assistant software configuration, then choose LED_STRIP options.
• Finally into the CF assistant software LED Strip Page to setup various states.

Specifications

Package Includes

• 1 x WS2812B RGB 5050 LED