The WLXY WL-3515 Desoldering Braid Solder Wick is finely braided from high quality copper wire and comes in a roll. It allows you to easily and thoroughly remove the extra solder from components or pads on the circuit board without causing any damage or component removal. Hence, it is widely used in the rework and repair of printed circuit boards, computers, cellphones or other electronics. A variety of width options are available to suit your needs. Don't hesitate to get one!

Features

• Finely braided from high quality copper wire, come in a roll
• Allow you to easily and thoroughly remove the extra solder from components or pads on the circuit board
• Won't cause any damage to the board or remove the onboard component
• Widely used in the rework and repair of printed circuit boards, computers, cellphones or other electronics
• Easy to use
• A variety of width options are available to suit your needs How to use:
• Place the desoldering wick over the solder to be removed, then push the heated soldering iron tip onto the desoldering wick and the solder will be absorbed
• Remove the desoldering wick after the solder has been absorbed
• Cut off the used section of the wick
• Repeat steps 1, 2, 3 if the solder is not removed completely (absorbability may differ depending on the type of solder) Caution: Do not force the tip against the desoldering wick to avoid injury to yourself or damage to the parts and PCB Do not heat the desoldering wick for more than 5 seconds to avoid damage to the parts and PCB

Specifications

Package Includes

• 1 x Desoldering Braid Roll